How to record a match
One person can do this. Arrive half an hour before kick-off; setting up takes about fifteen minutes. Everything on the camera stays on automatic.
1The night before
- Charge everything. The camera, the spare battery and the power bank. One battery films about 100 minutes in 8K, and a match with the warm-up is longer.
- Record to the memory card. Put the 256 GB microSD card in and set the camera to save there, not to its own memory, which is too small for a whole match. A match takes about 1.1 GB a minute: make sure about 130 GB is free.
- Settings: 360° video, 8K, 30 frames per second. Leave everything else on automatic.
- Wind noise reduction on. It's in the audio settings on the camera's screen (sometimes under PRO). The label can differ between software versions.
- Pack the bag: camera, stand, the screw pin if it's loose, spare battery or power bank, a lens cloth. A sandbag if you have one.
2At the pitch
- Halfway line, 2–3 m back. Put the stand level with the halfway line, 2–3 m behind the touchline. Closer than that and play right in front of the camera can drop out of the picture; much further back and the far side gets small. Keep clear of the assistant referee's run and the benches.
- Pin up, camera on. Screw the pin on top of the stand upright, thin end (1/4″) up. Screw the camera onto it, hand-tight.
- All the way up: 4 m. Extend every section fully. The height is what lets the camera see the far side.
- Weigh it down. Spread the feet wide and hang your bag low on the stand, or put a sandbag on the feet. A gust of wind on a 4 m pole is the biggest risk to the camera.
- Clean both lenses. A fingerprint or a raindrop shows for the whole match.
- Lenses toward the goals. One lens faces each goal. To aim, loosen the knob of the top section and turn that section, not the camera, so it stays tight on its screw.
- Take one photo of the setup with your phone. If something looks odd later, it helps us find out why.
- Tell people. Let both teams and the referee know the match is being filmed.
3During the match
- Start five minutes before kick-off. Press record, then check on your phone in the DJI Mimo app that it's really recording: play back a few seconds.
- Don't touch the stand during a half. Not to move it, not to adjust it. If it's in someone's way, move it at half-time.
- At half-time: stop recording, swap the battery or plug in the power bank, and start again. Check the camera hasn't worked loose on its screw. Two recordings are fine: we join the halves into one match.
4Afterwards
- Check both halves are on the card. Don't delete anything until your match is online.
- At home: plug the camera into a laptop and send the match with our uploader. It takes a while for a whole match, so leave the laptop on overnight.
- We take it from there. We make the match video, a person checks it, and you get the link to share with the team.
What goes wrong most often
- Recording to the camera's own memory. It fills up in the second half. Set it to the microSD card the night before.
- The battery runs out. One battery doesn't last a whole match with the warm-up. Swap it or plug in the power bank at half-time.
- Forgetting to start again after half-time. Check the recording light before the second half kicks off.
- Turning the camera instead of the top section. The camera works loose, and the lenses end up pointing the wrong way. Aim with the top section.
- The stand isn't fully up, or isn't weighed down. Lower means a smaller far side; no weight means it can blow over.
- A dirty or wet lens. Wipe both before kick-off and again at half-time when it rains.
- Moving the stand during a half. The picture jumps, and the software has to find the pitch again.
Not sure about your pitch? Ask when you create your team and we'll look at it with you.